как се свива цигара?

..как точно се свива?имам лист4ета оцб ама все нестава като хората
я ми обяснете по-одробно ако можете

[iNsaNE`giRL]

s mashinka

[IlLuSi0nS`]

дам с машинка най-добре.. ама може и на ръка.. ако ти е трудно отначало може да ползваш молифче но най-добре намери некой да ти покаже ха

kfa e taq ma6inka?

прсто все 1 го увивате на молив ли тряа да стане?не се ли прави някфо клюпче или и дедазнам и аз кфо накрая откъдето дърпате?н-иначе няа ли да ти попадне в устата тревата

[Fukc/cenzura lek/]

Step 1:
Load it Start with the rolling paper "sticky side up." Keep in mind that loading too little marijuana will result in a "pinner," while loading too much will prevent the joint from closing properly.
Step 2:
Shape it Carefully shape the joint by rolling it back and forth until the weed in the rolling paper is evenly dispersed and cylindrical in shape.
Step 3:
Roll it Roll the bottom end of the paper up and tuck it over the top of the weed while pulling end to end (to ensure tightness). Continue to roll the paper from the bottom up until only the sticky strip is showing.
Step 4:
Lick it Lick the sticky strip of the paper and seal the joint. Lightly twist both ends of the joint so that weed isn't sucked into your mouth as you inhale.
Step 5:
Spark it Hold the joint in your mouth (or in your hand as shown) and spark it up. If the joint has trouble igniting, give it a few puffs and suck the flame towards the joint.